MAGISK Full Res RAW + JPEG [STAR]

[Arnova8G2]

A Magisk Module made by Arnova8G2 that allows the users to have 50MP JPG and RAW on GN2 Lens and 48MP JPEG and RAW on both IMX586.
This allows better photo quality at daylight at the cost of each photo takes more storage.
Should work with all 7.x and 8.1/8.2 GCam Ports and Photon Camera.
Tested only on Mi 11 Ultra Weekly EU.

Bootloop?
Delete following folder via TWRP:

Code:

/data/adb/modules/highresmi11u

 
Installation:

• Requires Unlocked bootloader;
  
• Have Magisk V23 installed;
  
• Chinese ROM or any Chinese Based;
  
• Flash the Module on Magisk and reboot.
  

Bugs:

• Stock Camera is not usable;
  
• Focus is slow;
  
• Video is not good;
  
• Viewfinder is poor quality on apps like Instagram Story (final result is fine).
  

[jason.zhangfan]

it doesn't work with my version. i cannot even get preview of gcam after flashing it.

[techinbermudas]

it doesn't work with my version. i cannot even get preview of gcam after flashing it.

works fine on every version tested (Arnova, Wichaya, Greatness) without any configuration.

[jason.zhangfan]

it doesn't work with my version. i cannot even get preview of gcam after flashing it.

works fine on every version tested (Arnova, Wichaya, Greatness) without any configuration.

I flashed the module and rebooted. Then if I open gcam fast enough the whole system will freeze. But if I can wait for 2 minutes after login it is fine. The module works with 8.2gcam but not 8.3.256. It struggles on focusing really works fine....i cannot get back to use 12M now. Thank you!

[techinbermudas]

it doesn't work with my version. i cannot even get preview of gcam after flashing it.

works fine on every version tested (Arnova, Wichaya, Greatness) without any configuration.

I flashed the module and rebooted. Then if I open gcam fast enough the whole system will freeze. But if I can wait for 2 minutes after login it is fine. The module works with 8.2gcam but not 8.3.256. It struggles on focusing really works fine....i cannot get back to use 12M now. Thank you!

read the requirements.
8.3 is not ready yet for it.

Well what about removing the module?

[k7094]

Hello developer, I am using Mi 10Ultra system version is miui12.0.15 Android 12, after enabling the Fill Res magisk module of Mi 10Ultra, all cameras will be unavailable. My steps are: open GCam, load config, enable module, reboot. Can you help me?